Design of Horizontal and Vertical Alignment for the Centerline of a Federal Highway

Автор: Sarmad Dashti Latif

Журнал: International Journal of Engineering and Manufacturing @ijem

Статья в выпуске: 3 vol.10, 2020 года.

Бесплатный доступ

Highway engineering standards are constantly improving. In this study, a design has been done for a horizontal and vertical alignment for the centerline of a federal highway. The construction cost and pavement design have been done according to the Malaysian public works department for the federal roads system (JKR). The results indicate that the designed highway has an adequate, accurate, and economical system based on the proposed data. Accordingly, the objective has been achieved since the reliability of the designed highway was 94%.

Highway design, Highway system, Horizontal and Vertical alignment

Короткий адрес: https://sciup.org/15017306

IDR: 15017306   |   DOI: 10.5815/ijem.2020.03.03

Список литературы Design of Horizontal and Vertical Alignment for the Centerline of a Federal Highway

  • Garber NJ, Hoel L a (2009) Traffic and highway engineering
  • Raji SA, Zava A, Jirgba K, Osunkunle AB (2017) Geometric Design of a Highway Using Autocad Civil 3d. Geom Des a Highw Using Autocad Civ 3d 4:2458–9403
  • Kaparias I (2017) Assessing network-level walkability in relation to highway design standards: the case study of Luxembourg. 1–13
  • Horowitz R, Varaiya P (2000) Control design of an automated highway system. Proc IEEE. https://doi.org/10.1109/5.871301
  • Malyshkina N V., Mannering FL (2010) Empirical assessment of the impact of highway design exceptions on the frequency and severity of vehicle accidents. Accid Anal Prev. https://doi.org/10.1016/j.aap.2009.07.013
  • Torbic, D.J., D.W. Harwood, D.K. Gilmore, R. Pfefer, T.R. Neuman, K.L. Slack, and K.K. Hardy. A Guide for Reducing Collisions on Horizontal Curves, NCHRP Report 550, Volume 7. Transportation Research Board, National Research Council, Washington, D.C., 2004.
  • Glennon, J.C., T.R. Neuman, and J.E. Leisch. Safety and Operational Considerations for Design of Rural Highway Curves, FHWA-RD-86-035, Federal Highway Administration, U.S. Department of Transportation, Washington, D.C., 1985.
  • Fitzpatrick, K., K. Balke, D.W. Harwood, and I.B. Anderson. Accident Mitigation Guide for Congested Rural Two-Lane Highways, NCHRP Report 440, Transportation Research Board, National Research Council, Washington, D.C., 2000.
  • Minnesota Department of Transportation. Minnesota Strategic Highway Safety Plan. Minnesota Department of Transportation, St. Paul, MN, June 30, 2007.
  • Easa, S.M. and Q.C. You. Collision Prediction Models for Three-Dimensional Two-Lane Highways. In the Transportation Research Record: Journal of the Transportation Research Board, Number 2092, National Research Council, Transportation Research Board, Washington, D.C., 2009, pp. 48-56.
  • Schneider IV, W.H., K. Zimmerman, D. Van Boxel, and S. Vavilikolanu. Bayesian Analysis of the Effect of Horizontal Curvature on Truck Crashes Using Training and Validation Data Sets. In the Transportation Research Record: Journal of the Transportation Research Board, Number 2096, National Research Council, Transportation Research Board, Washington, D.C., 2009, pp. 41-46.
  • Bonneson, J.A. and M.P. Pratt. Model for Predicting Speed Along Horizontal Curves on Two-Lane Highways. In the Transportation Research Record: Journal of the Transportation Research Board, Number 2092, National Research Council, Transportation Research Board, Washington, D.C., 2009, pp. 19-27.
  • Fitzpatrick, K., L. Elefteriadou, D.W. Harwood, J.M. Collins, J. McFadden, I.B. Anderson, R.A. Krammes, N. Irizarry, K.D. Parma, K.M. Bauer, and K. Passetti. Speed Prediction for Two-Lane Rural Highways, FHWA-RD-99-171, Federal Highway Administration, U.S. Department of Transportation, McLean, VA, August 2000.
  • Fitzpatrick, K., I.B., Anderson, K.M. Bauer, J.M. Collins, L. Elefteriadou, P. Green, D.W. Harwood, N. Irizarry, R. Koppa, R.A. Krammes, J. McFadden, K.D. Parma, K. Passetti, B. Poggioli, O. Tsimhoni, and M.D. Wooldridge. Evaluation of Design Consistency Methods for Two-Lane Rural Highways, FHWA-RD-99- 173, Federal Highway Administration, U.S. Department of Transportation, McLean, VA, August 2000.
  • Malaysia, Standard (2012) Malaysian Standard. Chrysanth Stand
  • Findley DJ (2016) Highway Geometric Design. In: Highway Engineering: Planning, Design, and Operations
  • Chang AS, Tsai CY (2015) Sustainable design indicators: Roadway project as an example. Ecol Indic. https://doi.org/10.1016/j.ecolind.2015.01.036
  • Ko M, Lord D, Zietsman J (2012) Environmentally conscious highway design for crest vertical curves. Transp Res Rec. https://doi.org/10.3141/2270-12
  • Findley DJ (2016) Horizontal and Vertical Alignment. In: Highway Engineering: Planning, Design, and Operations
  • Gibreel GM, Easa SM, El-Dimeery IA (2001) Prediction of operating speed on three-dimensional highway alignments. J Transp Eng. https://doi.org/10.1061/(ASCE)0733-947X(2001)127:1(21)
  • Pearson D (2011) Pavement Design. In: Deterioration and Maintenance of Pavements
  • Santos J, Ferreira A (2013) Life-cycle cost analysis system for pavement management at project level. Int J Pavement Eng. https://doi.org/10.1080/10298436.2011.618535
  • O’Flaherty, C.A. Introduction to pavement design. Highways 2002, 225–266, doi:10.1016/b978-075065090-8/50011-9.
  • Austroadds (2018) Guide to Pavement Technology Part 2: Pavement Str
Еще
Статья научная