Modification of portland cement with nanoadditives

Автор: Farit A. Agzamov, Aleksander Y. Grigoryev

Журнал: Nanotechnologies in Construction: A Scientific Internet-Journal @nanobuild-en

Рубрика: Application of nanomaterials and nanotechnologies in construction

Статья в выпуске: 4 Vol.14, 2022 года.

Бесплатный доступ

Introduction. Portland cement slurries (suspensions) used for well cementing have high water-cement ratios (0.45–0.6). They also contain a minimum amount of inert fillers, must have zero water separation and controlled hardening with a minimum time between the start and end of setting. Literature review. Most of the scientific work on the use of nano-additives in binder systems relates to the construction industry. Nanosilicon, nanotitanium, nanocarbonate, nanoclays, carbon nanofibers, etc. were widely used as modifiers of cement systems, which showed an increase in the strength characteristics of the resulting concretes. Literature review showed that there is a very wide range of concentrations of nanoadditives in cement systems from 0.001 to 10.0%. An increase in the strength of cement with high concentrations of additives in a number of publications is explained by a decrease in its capillary porosity due to clogging of the pore space. However, nanoadditives should not play the role of microfillers in the hardened stone. They should work in cement slurry at the stage of cement hydration and cement structure formation at concentrations less than 1.0%. Results and Discussion. The paper presents the results of experimental studies of the rheological properties and early strength of stone based on Portland cement with additives (0.01%) of nanocarbonate and nanoiron. The role of nanoadditives is to increase the rate of cement hydration by reducing the activation energy, and accelerating the dissolution of the solid phase in the liquid. Nanoadditives can be a “substrate” on which two-dimensional nuclei of a new phase are formed. The probability of the appearance of two-dimensional nuclei on the substrate is much higher than for the formation of three-dimensional nuclei of a new phase in the bulk of the solution. Conclusion. The results show an ambiguous effect of additives on the tested parameters, which indicates the need to optimize the amount of additives. One of the reasons for the ambiguity of the results may be high water-cement ratios, which reduce the likelihood of the formation of “constrained” conditions in cement slurries. At the same time, the effects of accelerated cement hydration are “levelled” and the number of contacts between hydration products is reduced.

Еще

Nanoadditives, cement hydration, structure formation, rheology, compressive strength

Короткий адрес: https://sciup.org/142234632

IDR: 142234632   |   DOI: 10.15828/2075-8545-2022-14-4-319-327

Список литературы Modification of portland cement with nanoadditives

  • Bulatov AI. Detective biography of the tightness of the support of wells. Krasnodar, Prosveshchenie-Yug; 2008.
  • Danyushevskiy V.S. Design of optimal structures grouting cements. M.: Nedra, 1978.
  • Agzamov FA, Kabdushev AA, Komleva SF, Bayutenov NA. Use of cement sludges with reduced fluid losses for cementing wells in Kazakhstan. Pollution Research. 2016; 35(4): 891–896.
  • Agzamov FA, Ismagilova ER, Self-healing cements are the key to maintaining the tightness of the well support. Part 1. Nanotechnologies in Construction. 2019;11(5): 394 –402. Available from: https://doi.org/10.15828/2075-8545-2019-11-5-394-402.
  • Bekbaev AA, Agzamov FA. Dispersed reinforcement as a factor in improving the quality of lightweight cement mortars. Construction of oil and gas wells on land and at sea. 2018; 8: 38–42.
  • Yusifzadeh HQ, Edwards EJ, Shahbazov Jr, Kaziov AA. Technologies of Oil and Gas Well Drilling. Baku: 2014.
  • Suleymanov BA, Veliev EF. On the influence of granulometric composition and nanoscale additives on the quality of insulation of the tube space in the process of cementing wells. Proceedings of SOCAR. 2016;4: 4–10. Available from: https://doi.org/10.5510/OGP20160400293.
  • Murtaza M, Rahman M, Al-Majed A. Effect of nanoclays on mechanical and rheological properties of cement sludge of oil wells in HPHT environment. International Conference on Petroleum Technologies. 2016. Available from: https://doi.org/10.2523/IPTC-18989-MS.
  • De la Roij R. Egyed C, Lips JP. Nano-engineered oil wells cement improves flexibility and increases compressive strength: a laboratory study. Society of Petroleum Engineers. 2012. Available from: https://doi.org/10.2118/156501-MS.
  • Kravchenko IV, Kuznetsova TV, Vlasova NG, Yudovich BE. Chemistry and technology of special cements. – M.: Stroyizdat, 1979.
  • Ridha S, Yerikania U. New nano-geopolymer cement system improves wellbore integrity upon acidizing job: experimental results. Society of Petroleum Engineers. 2015. Available from: https://doi.org/10.2118/176419-MS.
  • Sanchez F, Sobolev K. Nanotechnologies in concrete. А review. Construction and construction materials. 2010;24(11): 2060–2071. Available from: https://doi.org/10.1016/j.conbuildmat.2010.03.014.
  • Muhd Norhasri MS, Hamidah MS, Mohd Fadzil A. Applications of using nanomaterial in concrete: A review. Construction and building materials. 2017;133: 91–97. Available from: https://doi.org/10.1016/j.conbuildmat.2016.12.005.
  • Nanotechnology in cement-based construction. Edited by Antonella D’A, Annibale LM, Filippo U. Imprint by Jenny Stanford Publishing. Available from: https://doi.org/10.1201/9780429328497.
  • Oltulu M, Sahin R. Single and combined effects of nano-SiO2, nano-Al2O3 and nano-Fe2O3 powders on the compressive strength and capillary permeability of cement mortar containing silica fume. Materials Science and Engineering. 2011;528(22–23): 7012–7019. Available from: https://doi.org/10.1016/j.msea.2011.05.054.
  • Hui Li, Hui-gang Xiao, Jie Yuan, Jinping Ou. Microstructure of cement mortar with nano-particles. Composites Part B: Engineering. 2004; 35 (2):185–189. Available from: https://doi.org/10.1016/S1359-8368(03)00052-0.
  • Jalal M, Fathi M, Farzad M. Effected of fly ash and TiO2 nanoparticles on rheological, mechanical, microstructural and thermal properties of high-strength self-compacting concrete. Mechanics of materials. 2013;61: 11–27. Available from: https://doi.org/10.1016/j.mechmat.2013.01.010.
  • Shiho Kawashima, Pengkun Hou, David J.Corr, Shah SP. Modification of cement-based materials with nanoparticles. Cement and concrete composites. 2013;36: 8–15. Available from: https://doi.org/10.1016/j.cemconcomp.2012.06.012.
  • Xiaoyan Liu, Lei Chen, Aihua Liu, Xinrui Wang. Influence of Nano-CaCO3 on the properties of cement paste. Energy Process. 2012; 16(B): 991–996. Available from: https://doi.org/10.1016/j.egypro.2012.01.158.
  • Sato T, Diallo F. Seeding effect of nano-CaCO3 on the hydration of tricalcium silicate. Journal of the Transportation Research Board. 2010; (2141): 61–67. Available from: https://doi.org/10.3141/2141-11.
  • Sato T, Beaudoin JJ. Effect of nano-CaCO3 on the hydration of cement-containing additional cementing materials. Advances in Cement Research. 2011; 23(1): 33–43. Available from: https://doi.org/10.1680/adcr.9.00016.
  • Metaxa Z, Konsta-Gdoutos M, Shah SP. Mechanical properties and nanostructure of cement-based materials reinforced with carbon nanofibers and polyvinyl alcohol (PVA) microfibers. Materials Science. Polymer Journal. 2010. Available from: https://doi.org/10.14359/51663743.
  • Gerrit L, Dietmar S. Control cement hydration with nanoparticles. Cement and concrete composites. 2015;57:
  • 64–67. Available from: https://doi.org/10.1016/j.cemconcomp.2014.12.003.
  • Artioli G, Ferrari G, Dalkoni MC, Valentini L. Nanosemines as modifiersof the cement hydration kinetics. Materials Science. 2020. Available from: https://doi.org/10.1016/B978-0-12-817854-6.00010-6.
  • Ledenev VV, Yartsev VP, Strulev SA, Odnolko VG. The influence of nanomodification on the strength and mobility of cement concretes and the development of foam concrete. Voprosy sovremennoi nauki i praktika. 2012;37(1): 24–29.
  • Taylor H. Khimiya cementov. M.:Stroyizdat;1969.
  • Mchedlov-Petrosyan OP. Modern views on the processes of cement hardening. New in the technology and technique of cement production. Proceedings of the Yuzhgiprocemet Institute. M.: Gosstroyizdat;1963: 144–152.
  • Ratinov VB, Rosenberg TI. Additives to concrete. M.: Stroyizdat;1973.
  • Polak AF, Physical and chemical bases of corrosion of reinforced concrete. Elementary corrosion processes: training. Ufa State Petroleum Technological University;1982.
  • Kuznetsova TV, Kudryashov IV, Timashev VV. Physical chemistry of astringent materials: a textbook for chem.-technol. M.: Vysshaya. shk.;1989.
  • Chernyshov EM, Artamonova OV, Slavcheva GS. Nanomodification of cement-based composites in the technological life cycle. Nanotechnology in construction. 2020;12(3): 130–139. Available from: https://doi.org/10.15828/2075-8545-2020-12-3-130-139.
Еще
Статья научная